Highways

Drivers urged to follow five rules through roadworks

National Highways recorded about 6,300 vehicle incursions in its roadworks in 2024, highlighting the risks faced by road crews.

Drivers are being reminded to follow five key rules when travelling through roadworks, after National Highways recorded about 6,300 vehicle incursions on its network in 2024.

The figure, published in National Highways’ annual report and accounts for 2024-25, was almost three times the approximately 2,100 incursions recorded in 2023. National Highways attributed the increase partly to higher traffic volumes on England’s motorways and major A roads.

The advice has been issued during Brake’s Road Safety Week, which runs from 15 to 21 November under the theme “Safe People on the Move”.

Five rules for drivers

  1. Obey temporary speed limits. Rule 288 of the Highway Code states that drivers must not exceed a temporary maximum speed limit. The requirement is set out under section 16 of the Road Traffic Regulation Act 1984.
  2. Do not change lanes to overtake queues. Drivers should remain in their lane rather than attempting to pass stationary or slow-moving traffic within a roadworks layout.
  3. Merge in turn when a lane closes. Drivers should use both lanes until the closure point and merge alternately where it is safe to do so.
  4. Never drive through a coned-off area. Cones and other temporary barriers separate live traffic from workers and works vehicles.
  5. Watch for works vehicles entering or leaving the site. Drivers should slow down, remain alert and allow space for vehicles operating around the roadworks.

Average speed cameras may operate where an “Average speed check” sign is displayed. The cameras can read number plates during the day and at night, with evidence sent to the police for decisions on prosecution.

National Highways also warns that a Red X closes a lane that may contain people working. Ignoring one can result in a fixed penalty of up to £100 and three penalty points.

Incursions and abuse

The December 2025 report from the IPV and Incursion Working Group recorded 2,833 incursions during 2025, a 54.5% reduction on 2024. It also recorded 128 strikes on impact protection vehicles since December 2019 and 311 incursions by emergency vehicles since February 2022.

Of 76 incursions recorded in December 2025, 38 were classified as intentional “to seek benefit”. The report noted that the reduction in incidents coincided with a lower roadworks workload.

The No Excuse for Roadworker Abuse campaign defines abuse as “any behaviour or situation that makes people working on the road feel unsafe, threatened or at risk”. This includes verbal abuse, threats, aggressive driving and entering works areas without permission.

National Highways says its traffic officers and supply chain staff “deserve respect not abuse”. Traffic officers have worn body cameras since a rollout was completed in February 2022. Anyone threatened or attacked should move to a safe place and call 999.

Technology used to protect crews

Incursion-warning systems such as Intellicone can alert workers when a vehicle enters a protected work area, sound an alarm to deter the driver and record the incident.

The December 2025 working group report said technology of this type was in use on around 56% of nights on National Highways roads, a three-percentage-point increase on the previous month. Other measures highlighted by National Highways include wireless CCTV, remote acoustic monitoring, drones and QR-code reporting for incursions.

Drivers are also advised to allow extra time, put distractions away and remain calm in congestion. As the campaign advice states, “getting angry won’t make the traffic move faster”.